DX-1944B INTERNAL CONDUCTIVE COATING

PRODUCT DESCRIPTION: 
DX-1944 is a blend of high priority graphite's and iron oxide dispersed in sodium silicate and deionized water. It is designed to be applied to the neck of cathode ray tubes to provide an electrically conductive surface.

FEATURES: 
The carefully controlled combination of finely ground conductive pigments, iron oxide and sodium silicate provides a very hard, smooth scratch resistant conductive surface. This smooth surface reduces the possibility of scratching off particles which may result in arcing and shorts in the electron gun of the
picture tube.

TYPICAL PRODUCT DATA:
Color: Dark Brown to black
Wt/Gallon: 11.5 lbs - .3 lbs
Total Solids: 41.5 ± 2.0%
viscosity: 150 cps ± 60 cps.
Ratio-Silicate/pigment .63 ± .07
Foreign Particles: on 50 mesh screen - none allowed.
On 270 mesh screen .1 Grams max.
per 16 oz of material.

APPLICATION: Brush

Reduction: 
None normally needed. Deionized water may be used.
Agitation: It is recommended that gentle agitation be provided
during use of this product in order to assure homo-geneous suspensions and therefore consistent coatings.

Drying: 
Best results are obtained when coating is baked for
at least thirty minutes at more than 300* F, before
gun shoving.

PERFORMANCE:
Conductivity - 200 - 500 ohms per inch.

STORAGE & HANDLING: 
Store in area above freezing. Use within six months of manufacture.
PACKAGING: one gallon plastic bottles (4 bottles per carton) 5 gallon steel pails, 55 gallon steel drums.

FOR INDUSTRIAL USE ONLY