DX-1939 INTERNAL CONDUCTIVE COATING


PRODUCT DESCRIPTION: 
DX-1939 Internal Conductive Coating is a blend of graphite, iron oxide and aluminum silicate dispersed in sodium silicate and deionized water. This material was formulated to provide a conductive coating on the inside of the funnel of cathode ray tubes.

FEATURES: 
Coating may be applied by brushing or spraying and produce smooth hard chalk resistant surfaces that reduce the potential for loose particles and high voltage arcing in cathode ray tubes. The pigments in DX-1939 do not settle to form a hard packed mass, but may be easily re-dispersed after long storage.

TYPICAL PRODUCT DATA:
Viscosity - 100 - 280 cps.
Wt/Gallon - 11.5 - 11.8 lbs.
Total Solids - 40 -43%
Resistance - 2100 + 500 ohms/inch

APPLICATION: 
Roll package at slow speed for at least one hour prior to use. Do not shake. If agitation is required, mix at slow RPM.
Product may be sprayed or brushed onto bulb.

REDUCTION: 
None normally needed. Deionized water may be used.

PACKAGING: 
Five and fifty-five gallon steel drums.

STORAGE: 
Keep from freezing. Use within six months after date of manufacture.

FOR INDUSTRIAL USE ONLY